 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-85299(AS)
3.4.8 Identification plate and markings. Nomenclature and identification
marking shall be in accordance with MIL-STD-130.
3.5 Soldering. All electrical soldered connections shall be in accordance
with MIL-STD-454, Requirement 5.
Workmanship shall be in accordance with MIL-STD-454,
3.6 Workmanship.
Requirement 9.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or
any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 Responsibility of compliance. All items must meet all requirements
of Sections 3 and 5. The inspection set forth in this specification shall
become a part of the contractor's overall inspection system or quality
program. The absence of any inspection requirements in the specification
shall not relieve the contractor of the responsibility of assuring that all
products or supplies submitted to the Government for acceptance comply with
all requirements of the contract. Sample tests of quality conformance does not
authorize submission of known defective material, either indicated or
actual, nor does it commit the Government to acceptance of defective
material.
The inspection requirements specified
4.2 Classification of inspections.
herein are classified as follows:
First article inspection (see 4.4).
a.
b. Quality conformance inspection (see 4.5).
4.3 Inspection conditions. Unless otherwise specified herein, all
inspections shall be performed in accordance with the conditions specified
in 3.4.3.
4.3.1 Performance characteristics.
4.3.1.1 Before tests. The test set shall be in accordance with the
requirements for interference control (see 3.4.2.1.1) and warm-up time
(see 3.4.3.2).
4.3.1.2 During inspection acceptance tests. The test set shall be in
accordance with the requirements of Section 3.
22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals