 |
|||
|
|
|||
| ||||||||||
|
|  MIL-H-15362B(Aer)
Installation - The test bench harness shall be designed primarily for
3.1.3.1
installation and operation on benches as specified in Bureau of Ships Drawing S9101-212410(latest
revision) but shall, to the greatest extent possible also be designed for installation and operation
on benches as specified in Specification MIL- E- 15354
3. 1.3.2
Minimum Space - The test bench harness shall be designed so test the
harness, the associated test equipment, and the equipment being tested will occupy a minimum
space in the workshop.
3. 1.3.3
Size - The test bench harness shall be designed to pass through an opening
26 by 54 inches with rounded corners of 8 inches radius.
3.1.4
Associated Equipment - The test bench harness shall normally not include items
of test equipment (for example, signal generators, power supplies, dummy loads, voltage.
urrent and frequency measuring devices, etc. ) but shall to the greatest practical extent be designed
to facilitate the use of all such equipment as may be required in the test and maintenance of the
avionic equipment for which the harness is intended.
3. 1.5
Special Test Equipment - The test bench harness shall normally not include
any special test equipment unless specifically authorized by the Bureau of Aeronautics. When
specifically authorizes such test equipment shall conform to the requirements of Specification
MIL-T-21200.
3.2
General
3. 2.1
Materials, Parts and Processes - The requirements for materials, parts
and processes shall be in accordance with Specification MIL- T- 21200 unless otherwise specified
herein.
3. 2.2
Design and Construction - The design and construction of the test bench
harness shall be in accordance with the applicable requirements of Specification MIL-T-21200.
3.2.3
Interchangeability - The test bench harness shall conform to the inter-
changeability requirements of Specification MIL-T-21200.
Workmanship - Workmanship shall be in accordance with the requirements
3. 2.4
of Specification MIL-T-21200.
3.3
Identification and Marking - The test bench harness shall be identified and
marked as follows:
3.3.1
Nomenclature and Nameplates - Nomenclature assignment and nameplate
approval for test bench harness identification shall be in accordance with the requirements of
Specification MIL-N-18307. 18307.
3, 4
Workshop Primary Power - The test bench harness shall be designed on
the basis that the following operating power is available in workshops in which the test bench
harness is to be used.
Voltage
Frequency
Phase
------
28
D. C.
208
400
1
400
115/200
3
115
400
1
115
60
1
440
60
3
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals