 |
|||
|
|
|||
| ||||||||||
|
|  MIL-L-45935A
*
4.5.3.4 Trigger pull, safety actuating torque, pressure resistance
and functioning. Each launcher shall be tested for trigger (see
3.2.3.9), safety actuation torque (see 3.2.3.112), pressure resistance
and functioning (see 3.3.1) using the test methods specified in 4.7.2.4,
4.7.2.5 and 4.7.4 respectively. Failure of the launcher to pass any of
the test shall be cause for rejection.
4.5.3.5 Leaf sight alinement testing. Prior to mounting on the
handguard assembly, each leaf sight assembly (see 3.2.5) shall be tested
for alinement as specified in 4.7.3.
*
4.5.3.6 Endurance testing. One launcher randomly selected from
each inspection lot shall be tested for endurance (see 3.3.2) using the
test method specified in 4.7.5. If the endurance requirements are not
met, the represented lot shall be rejected. Upon completion of the en-
durance test looseness of the barrel extension is permissible.
*
4.5.3.7 Targeting and accuracy testing. One launcher randomly
selected from each inspection lot shall be fired for targeting and accuracy
(see 3.3.3) using test methods specified in 4.7.6. Failure of launcher
to meet the targeting and accuracy requirements shall be cause for rejection
of the represented lot. A sample of two launchers from each reconditioned
lot shall be tested using the procedure specified above.
4.5.3.8 Interchangeability testing.
4.5.3.8.1 In plant.
*
4.5.3.8.1.1 Launchers. Ten launchers randomly selected from
each inspection lot shall be tested for interchangeability (see 3.4) using
the test methods specified in 4.7.7.1.1. Launchers taken for interchange-
ability testing shall have been found satisfactory in all other exam-
inations and tests. The 10 launchers shall be tested for and shall
comply with the requirements for firing pin indent (see 3.2.3.7) and firing
pin protrusion (see 3.2.3.8) after interchange of parts using the test
methods specified in 4.7.2.2 and 4.7.2.3 respectively. In addition,
the launchers shall be examined for functioning of safety (see 3.2.3.11)
and shall be tested for safety actuation torque (see 3.2.3.11.2, fun-
ctioning (see 3.3.1), and targeting and accuracy (see 3.3.3) require-
ments after interchange of parts using the test methods specified in
4.7.2.5, 4.7.4 and 4.7.6 respectively. No malfuctions or failures
shall be allowed. Failure of any launcher to pass any of the tests or
requirements specified above shall be cause for rejection of the repre-
sented lot. A sample of 20 launchers from each retest or reconditioned
lot shall be tested using the test procedures specified above.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals