 |
|||
|
Page Title:
Lifting time for auxiliarv hand pump system |
|
||
| ||||||||||
|
|  MIL-L-85532(AS)
4.8.2. 11.3
Lifting time for auxiliarv hand pump system. The
auxiliary hand pump -ysystem shall demonstrate the ability to lift a 4500
s
pound weapon or store from 2 to 89 inches in five minutes or less with
the engine off.
Manipulator head. The loader with a 4500 pound
4.8.2.12
weapon or store in place shall demostrate the ability to move the weapon
or store longitudinal centerline in the following manner:
Yaw - Yaw 90 degrees both right and left.
a.
b.
Pitch (tilt) - Tilt 15 degrees both up and down.
Lateral - Move laterally 4 inches.
c.
d.
Longitudinal - Move longitudinally 3 inches.
Roll - Roll 17 degrees up and 13 degrees down.
e.
Forks. When the lifting boom is in its lowest
4.8.2.13
position, it shall be demonstrated that the fork tines car, be easily
.
removed from the manipulator head.
Cycle. The loader shall be subjected to a cycle test
4.8.3
in accordance with the procedures of 4.8.2.11, 4.8.2. 11.1 and 4.8.2.12
for each test procedure. At the end of these tests the
for
loader shall show no evidence of yield in any component that could in any
manner prevent the loader from meeting the operational requirements.
Noise limits. The loader shall be subjected to duty
4.8.4
cycle tests in lieu of the steady state test of MIL-STD-1474, The
continuous noise level (Lcq*) shall be measured at the operator's station
in accordance with MIL-STD-1474. Accumulative noise exposure measurement
shall require a minimum of one hour of unloaded continuous operation on
the test course. Throughout the test the loader shall meet the noise
level requirements.
Electromagnetic radiation. The loader shall be
4.8.5
tested in accordance with MIL-STD-461 and shall meet the requirements of
3.8.4. in addition, the electromagnetic radiation report shall include
results of all testing and a list of components used to reduce the
electromagnetic radiation.
Environmental tests.
4.8.6
4.8.6.1
High temperature, The high temperature test shall be
conducted in accordance with Test Method No. 3 of Appendix A.
Low temperature, The low temperature test shall be
4.8.6.2
conducted in accordance with Test Method No. 4 of Appendix A.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals