 |
|||
|
Page Title:
Figure 4. Preset and clear switching test circuit for device types 01 and 02. |
|
||
| ||||||||||
|
|  MIL-M-38510/61C
GENERATOR CHARACTERISTICS
TC
VIH2
VIL2
10 mV
10 mV
25C
+1.11 V +0.31 V
125C
+1.24 V +0.36 V
-55C
+1.01 V +0.28 V
zOUT = 50Ω
tP (P/S & CLR) = 40 ns
PRR = 1 MHz
Device type 01
tTHL = 2.0 ns (20%-80%)
tTLH = 2.0 ns (20%-80%)
Device type 02
tTHL = 1.5 ns (20%-80%)
tTLH = 1.5 ns (20%-80%)
RL
2 = 50Ω 5%
SCOPE INPUT = 50Ω to GND
CL (test jig) ≤ 5 pF
NOTES:
1. Perform test in accordance with test table; each output is tested separately.
2. All input and output cables are equal lengths of 50 ohm coaxial cables. Wire length should be ≤ .250
(6.35 mm) from tp in to input pin and tp out to output pin.
3. Outputs not under test connected to a 100 ohm resistor to ground.
4. Note that observed pulse amplitude is attenuated by one half.
FIGURE 4. Preset and clear switching test circuit for device types 01 and 02.
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals