 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-46314B(MU)
4.4.2 Failure of sample.- Should any one item of a special sampling
fail to meet the specified test requirements, acceptance of the represented
inspection lot will be suspended by the Government until necessary correc-
tions have been made by the contractor and the resubmitted samples have been
approved (see 4.3.2,3).
4.5 Inspection equipment.- Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment in
accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment.- Where the contract
provides for Government furnished test equipment, supply and maintenance of
test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design.- Unless otherwise specified in the contract,
all inspection equipment specified by drawing number in specifications or
SQAP forming a part of the contract shall be supplied by the contractor in
accordance with technical data provided with the Technical Data Package (TDP).
4.5.2.2 Contractor design.- The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
procedures specified in "Examination" and "Test Facilities" requirements
of MIL-F-13926. Since tolerance of test equipment is normally considered to
be within 10% of the product tolerance for which it is intended, this inherent
error in the test equipment design must be considered as part of the pre-
scribed product tolerance limit. Thus, concept, construction, materials,
dimensions and tolerance used in the design of test equipment shall be so
selected and controlled as to insure that the test equipment will reliably
indicate acceptability of a product which does not exceed 90% of the pre-
scribed tolerance limit, and permit positive rejection when non-conforming.
Construction shall be such as to facilitate routine calibration of test
equipment.
4.5.3 Test equipment.- In conjunction with 4.5.2.2, the following
standard test equipment shall be utilized in the performance of the applicable
tests as specified in 4.6.
8.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals