 |
|||
|
Page Title:
Table 3. Physical properties at high and low temperatures. |
|
||
| ||||||||||
|
|  MIL-M-46861B (MI)
TABLE III. Physical properties at high and low temperatures.
Characteristics
Average Minimum
Individual Minimum
Test
Paragraph
at 68.3C
at -
at 68.3C
at 53.9C
53.9C
Flexural strength
ultimate, psi x 103
30
58
22
50
4.8.6
Flexural modulus,
psi x 106
1.1
2.1
0.9
1.8
4.8.6
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or
purchase order, the contractor is responsible for the performance of all inspection
requirements (examinations and tests) as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified herein,
unless disapproved by the Government. The Government reserves the right to perform
any of the inspections set forth in this specification where such inspections are deemed
necessary to ensure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements of
sections 3 and 5. The inspection set forth in this specification shall become a part of
the contractor's overall inspection system or quality program. The absence of any
inspection requirements in the specification shall not relieve the contractor of the
responsibility of ensuring that all products or supplies submitted to the Government for
acceptance comply with all requirements of the contract. Sampling inspection, as part
of manufacturing operations, is an acceptable practice to ascertain conformance to
requirements, however, this does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to accept
defective material.
4.2 Classification of inspections. The inspection requirements specified herein
are classified as follows:
a.
First article inspection (see 4.4).
b.
Quality conformance inspection (see 4.5).
4.3 Inspection conditions. Unless otherwise specified herein, the following
conditions shall be used:
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals