 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-48245B(AR)
In addition, the first
See MIL-A-48078.
4.3.3 Rejection.
article quantity shall be rejected if any of the following occur:
a. The certification for either of the two silicas reveal
any failure to comply with any of the requirements specified on the
applicable drawing.
b. The certifications for the base resin or the hardener
is incomplete or indicates any constituent is missing.
The base resin or hardener exceeds the maximum
c.
viscosity.
d. The "molding compound tested fails to comply with any of
the requirements listed in Table I and Table II, or fails to comply
with the color requirement of 3.6.
Inspection lots shall comply
Inspection lot formation.
4.4.1
In addition,
with the lot formation provisions of MIL-A-48078.
inspection lots of base resin or hardener shall consist of that
quantity of material produced from the same batch of raw material
and which is both manufactured and offered for acceptance at one
time.
See MIL-A-48078.
4.4.2
Examination.
Unless otherwise specified in the
Sampling plans.
a.
Classification of Defects and Testing, sampling plans for major and
minor defects shall be in accordance with MIL-STD-105 Inspection
Level II.
Material samples in accordance with
Inspection.
b.
4.4.2.a for Quality Conformance Inspection shall conform to the
requirements of 4.4.2.1 to 4.4.2.6.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals