Enclosures with integral reservoir of lubricant.

Page Title: Enclosures with integral reservoir of lubricant.
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-M-52329C

3.254. Electromagnetic interference. The electromagnetic interference

characteristics of the asphalt plant shall conform to MIL-STD-461, class III C.

3.25 Lubrication. All surfaces requiring lubrication shall be provided

with suitable means for lubricating.

3.25.1 Lubricants. The mixing plant shall operate as required when lubri-

cated as specified herein.

3.25.2 Lubrication fittings. Lubrication fittings shall conform to MIL-

F-3541, types I, II, and III. Fittings shall be located in a protected posi-

tion and shall be accessible to a hand operated grease gun with a 10 inch

flexible extension. Accessibility to fittings shall be provided without the

removal or adjustment of accessories or parts. Where oil holes are applicable,

they shall have spring-loaded covers. Panels and plates equipped with hand-

operable, quick-disconnect fasteners maybe removed top provide accessibility.

3.25.3 Pressure-release device. A pressure-release device shall be pro-

vided where the use of pressure lubricating equipment will damage grease seals

or other parts.

3.25.4 Enclosures with integral reservoir of lubricant. Enclosures such

as gearcases and transmission housings which contain a reservoir of lubricants

for the lubrication of the parts enclosed shall be equipped with dipsticks,

finger holes, or sight holes to determine the level of the lubricant. Each

enclosure shall be equipped wirh a drain plug conforming to MS35844 or

MS49006, and with a means for filling the enclosure with lubricate. The drain

plug shall be located so that removal of the plu will result in complete

drainage of the lubricant from the enclosure. Intgral tubes or troughs may

be used to convey the lubricant from the drain outlet to the ground. Accessi-

bilty to the drain plug, the filling means, and the lubricant-level chacking

device shall be obtained without the removal or adjustment of accessories or

parts, except that panels and `plates equipped with hand-operable quick-disconnect

fasteners may be removed.

3.25.5 Grease lubrication. All grease lubrication, including lubrication

of sealed bearings, shall be with greases confoming to MIL-G-10924 or MIL-G-

23827 as applicable The mixing plant shall be run-in (broken-in) and de-

The bearings shall be cleaned before lubtrication

livered with these greases.

because military greases are not compatible with other greases. A tag shall

be attached in a conspicuous place on each unit to indicate which military

grease has been used.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business