 |
|||
|
Page Title:
Functioning of the electronic circuitry of the molded assembly-cont. |
|
||
| ||||||||||
|
| MIL-M-70779 (AR)
40.2.5
a) Type I: Non-
Low Voltage
At TA=+25C
functioning, or
+5C (+77
functioning less
10)
than.
b) Type I: Equal to
or greater than
3.2 volts but
less than 3.4
volts.
40.2.9
Less than 2.9 ohms
Detonator
(see note)
greater than 9.5
Resistance
ohms.
NOTE: This test shall be 100% performed on Part #9298451 prior to
molding, and precaution shaold be taken to assure that the solde
bridge is present to prevent inadvertent functioning of the
detonator during handling prior to test. Assurance shall be
provided that the solder bridge is removed immediately prior to
the resistance test so as not to invalidate test results.
Limits
Paragraph
Test
Output Capacitor
Improper
40.2.6
Voltage
a) Both circuits
40.2.12
Continuity
open.
b) One circuit
open.
40.2.14
Anti-disturbance
Switch Operation
The following tests shall be performed after adding the permanent
detonator short.
Absence of Short
40.2.11
Detonator Short
a) Equal to or less
40.2.10
Gas Generator II
than 1.1 ohms or
Piston Actuator
equal to or
Resistance
greater than 2.9
ohms.
b) Greater than 4.0
ohms but less
than 8.0 ohms.
50
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals