 |
|||
|
Page Title:
Section VII - Illustrated parts breakdown/repair parts and special tools list/parts catalog. |
|
||
| ||||||||||
|
|  MIL-M-82376B
narrowing the possible functional area of the fault. Tolerance values shall
be provided in those instances where a definitive "yes" or "no" is not
obtained. This progression and elimination shall isolate the functional area
of the equipment containing the fault and then refer the user to that portion
of the manual containing the information needed to complete the fault
isolation and repair. Each diagram shall include or make reference to
information establishing the initial conditions required for the fault
isolation procedure.
3.3.1.7.10 Parts location diagrams. (N) Where a nonillustrated parts
list refers to parts not shown in the technical manual or elsewhere (i.e.,
mechanical parts and parts not stamped with a part number or reference
designation) , line drawings shall be furnished showing callouts of the
interior of the major assemblies identifying all such parts. These
illustrations shall show and identify such parts by reference designation as
well as part name. Common mechanical assemblies used throughout the training
device shall be identified by one representative illustration. A note on such
an illustration shall state what these common assemblies are. Parts not used
on one of these assemblies shall be so indicated (e.g., MP3 not used on Unit
2A3).
3.3.1.8 Section VII - Illustrated parts breakdown/repair parts and special
tools list/parts catalog. This section shall contain the requirements
specified in 3.3.1.8.1 through 3.3.1.8.3.6.
3.3.1.8.1 Illustrated parts breakdown. (F) Unless otherwise specified by
the contracting activity, illustrated parts breakdown shall be prepared as a
separate manual in accordance with MIL-M-38807.
3.3.1.8.2 Repair parts and special tools list. (A) Repair parts and
special tools list shall be prepared in accordance with MIL-STD-335(TM).
3.3.1.8.3 Parts catalog. (N) The parts catalog shall catalog and
identify all repair parts in the training device. This section shall contain
the following:
a.
Introduction (see 3.3.1.8.3.1).
b.
List of manufacturers (see 3.3.1.8.3.2).
c.
List of major assemblies (see 3.3.1.8.3.3).
d.
Major assembly parts list (see 3.3.1.8.3.4).
e.
Numerical parts list (see 3.3.1.8.3.5).
f.
Reference designation list (see 3.3.1.8.3.6).
3.3.1.8.3.1 Introduction.
(N) An introduction section shall explain the
use of the parts catalog, use of abbreviations, codes, symbols, and other
0023E1
27
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals