 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-82376B
specific notations concerning the parts listed. Figure 17 is an example for
use as a guide in preparation of the "Introduction" to the parts catalog.
3.3.1.8.3.2 List of manufacturers. (N) The Commercial and Government
Entity Code (CAGEC) numbers, names, and addresses of the manufacturers shall
be listed numerically by code number as listed in DLSC H4-1 and DLSC H4-2 (see
figure 18).
3.3.1.8.3.3 List of major assemblies. (N) All major assemblies which
comprise the training device shall be listed in item number order. The
item number for each major assembly shall be obtained from column 1 of the
major assembly parts list (MAPL) (see 3.3.1.8.3.4). The list of major
assemblies shall include information shown in figure 19.
3.3.1.8.3.4 Major assembly parts list.
(N) The major assembly parts
list (MAPL), see figure 20, shall be prepared as follows:
a.
Major assemblies. (N) This list shall be prepared in major
assembly and subassembly sequence with the major assembly
nomenclature identified on each page of the list.
b.
Assemblies. (N) The main groups shall be broken down into
assemblies, subassemblies, and parts. Each item shall be
designated with an indenture number to indicate the relationship to
its next higher assembly (see 3.3.l.8.3.4g).
c.
MAPL. (N) The MAPL shall list in "Top Down Breakdown Order" all
installations, assemblies, and parts including assemblies which can
be disassembled or replaced as stated in the maintenance concept.
Identical assemblies used two or more times in an end equipment
shall be broken down at the first appearance. All other
appearances of this assembly shall be annotated; e.g. , "See Item
No.
for breakdown", in column 4. Potted, encapsulated,
riveted, or welded units, not susceptible to maintenance, shall not
be broken down.
(1) Unmodified Government-Furnished Property (GFP). (N) Unmodified
GFP provided for incorporation in the training device or
forming an integral part of the training device shall be
listed as a complete item under the appropriate assembly with
the applicable technical publication numbers as shown in
figure 21.
(2) Unmodified Contractor Acquired Operational Equipment (CAOE).
(N) Unmodified CAOE obtained from operational equipment
supplies, which form an integral part of the training device,
shall be listed as a complete item under the appropriate
assembly with the applicable technical publication numbers as
shown in figure 22.
28
0023E1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals