 |
|||
|
Page Title:
Table VIII. Width tolerances for flat wire (ribbon) |
|
||
| ||||||||||
|
|  MIL-N-46025B(MR)
Table VIII.
Width tolerances for flat wire (ribbon)
Width,
Tolerance, inch
inch
(plus and minus)
Up to 0.031, incl.
0.005
Over 0.031 to 0.061, incl.
.008
Over 0.061 to 0.099, incl.
.010
Over 0.099 to 0.187, incl.
.016
3.4.3 Length. If cut straight lengths are specified, the lengths shall
be within the limits as specified in table V.
3.4.4 Permanent set. The flat wire (ribbon) shall be sufficiently
rigid so that when 1-1/4 turns are cut free from a spool, the diameter
of the resulting loop shall not exceed the flange diameter of the spool
on which the wire is furnished.
3.5
Strip.
3.5.1 Thickness. The thickness of strip shall not vary by more
than the amounts shown in table IX.
(1)
Table IX.
Thickness tolerances for strip
Tolerance (all widths),
Thickness,
inch
inch
(plus and minus)
(2)
Under 0.006,
10
0.006 to 0.015, incl.
0.001
Over 0.015 to 0.050, incl.
.0015
Over 0.050 to 0.093, incl.
.0025
Over 0.093 to 0.125, incl.
.004
(1)
Measured 3/8 inch or more from edge except for strip under 1
inch in width which is measured at any place.
(2)
Expressed as percent of nominal thickness.
3.5.2 Width. The width of strip shall not vary by more than the amounts
shown in table X.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals