 |
|||
|
Page Title:
Test and inspection equipment facilities |
|
||
| ||||||||||
|
|  MIL-O-8114B(OS)
may differ from the quantity specified in the total order or contract.
In any event, all units of a single "inspection lot" shall be made to
the same design, with the same materials and manufacturing techniques,
and shall be part of one continuous production run.
4.3.3 Periodic pr oduction. samples. From each succeeding lot or grand
lot of 300 or less that have passed the quality conformance inspection of
4.4, a random sample of five oscillators will be selected for submission
to an activity designated by the procuring activity to determine compli-
ance of the samples with the requirements of the contract, specification,
and drawings. The oscillator: shall be considered satisfactory if they
meet all specification and pertinent drawings requirements and withstand
the tests specified in 4.4 and 4.5. Failure of the periodic production
sample to comply with these requirements will result in the rejection of
the lot, as determined by the procuring activity.
delivered under
-
4.4 Quality conformance inspection. Each o
contract shall be subjected to the following t
Failure to satisfactorily pass any test specif
cause for rejection.
4.4.1 Test conditions. Unless otherwise specified, the oscillator
shall be subjected to quality conformance tests under the following
conditions:
4.4.1.1 Temperature. Room ambient 65 degrees Fahrenheit (F) to 95
degrees F (18.33 degrees Centigrade (C) to 35 degrees C).
4.4.1.2 Altitude.
Normal ground.
4.4.1.3 Vibration
None.
4.4.1.4 Humidity.
Room ambient to 95 percent relative, maximum.
4.4.2 Test and inspection equipment facilities. The manufacturer
shall furnish and maintain all necessary test equipment and facilities
and shall provide personnel for performing all quality conformance tests.
The test equipment shall be adequate in quantity and, when definite re-
quirements are not specified, shall be of sufficient accuracy and quality
to permit performance e of the required acceptance tests.
4.4.3 Test equipment. The following items of test equipment are re-
quired to perform the quality conformance inspection set forth in this
specification:
4.4.3,1 Power supply capable of supplying the test circuit shown in
Figure 1 with electrical power conforming to the following requirements:
The electrical power used to operate the
4.4.3.1.1 Filament power:
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals