 |
|||
|
Page Title:
Table II - Onboard repair parts |
|
||
| ||||||||||
|
|  MIL-P-21397C(SHIPS)
3.12,5 Two copies of' technical manufals shall be packed with each proportioning tit. Additional copies
shall be furnished as specified (see 6.1). If final technical manuals are not available at the time units are
shipped, then two copies of preliminary technical manuals shall be packed with each proportioning unit.
The
final manuals shall be delivered at a later time as specified in MIL-M-15071.
3.13 Repair parts and tools.
3.13.1 Onboard. Repair parts shall be furnished and processed in accordance with method B (paragraph
3.3.2) of MIL-P-15137 (see 6.3) and as specified in the contract.
3.13.2 Each set or repair parts and tools specified in the contract or order shall contain the parts list-
ed in table II as a minimum. Unless otherwise specified in the contract or order, the quantity of repair parts
per set shall be based on one pump per ship.
Table II - Onboard repair parts.
#
#
3.13.2.1 On all procurements the manufacturers part number (vendor's number w/FSCM's) shall be entered
in addition to the prime contractor part number and manufacturer's Federal Code (FSCM).
3.13.3 Repair parts for motors, and controllers, shall be furnished in accordance with the applicable com-
ponent specifications or as specified in the contract or order.
Special too1s and wrenches.
3.73.4
3.13.4.1 Each set of onboard repair parts shall include a complete set of all special tools and wrenches
required for maintenance of the pumps, gears and drivers. Special tools are defined as those tools not listed
in the Federal Supply Catalog, (Copies of this catalog may be consulted in the office of the DCAS).
3.13.4.2 One set of special operating tools and wrenches shall be furnished with each proportioning unit,
and shall include all wrenohes and tools required for the operation of the complete proportioning units, Each
set of special operating tools and wrenches shall be furnished in separate boxes. If there are no more than
two such tools per set they may be attached to the pumps in a secure but readily accessible manner, rather than
boxed .
3.13.4.3 Each tool or wrench shall be indelibly marked indicating the intended purpose.
3.13.4.4 Tools which are available in the Federal Supply Catalog, such as common wrenches and standard
pullers, will not be required, Standard complete or limited sets of pullers or parts of puller sets in accord-
ance with GGG-P-781
shall be identified as to type and use in notes on the outline or section assembly drawings.
Special tools shall be detailed, and included in the list of material.
3.13.4,5 Each box containing onboard repair parts shall contain a list entitled "List of onboard repair
parts and tools", The list shall be in a format for use on outline drawings and in the technical manuals. It
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals