 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-29191B(YD1)
4.1.1 Responsibility for compliance. All items shall meet all requirements
of sections 3 and 5. The inspections set forth in this specification shall
become a part of the contractor's overall inspection system or quality program.
The absence of any inspection requirements in the specification shall not
relieve the contractor of the responsibility of ensuring that all products or
supplies submitted to the Government for acceptance comply with all requirements
of the contract. Sampling inspection, as part of manufacturing operations, is
an acceptable practice to ascertain conformance to requirements, however, this
does not authorize submission of known defective material, either indicated or
actual , nor does it commit the Government to accept defective material.
The inspection requirements specified
4 2 Classification of inspections
herein are classified as follows.
First article inspection (see 4.3).
Quality conformance inspection (see 4.4) .
4.3 First article inspection
The first article inspection shall be
performed on one workboat platform when a first article is required (see 3.2 and
6.2). This inspection shall include the examination of 4.5 and the tests of
4.6. The first article may be either a first production item or a standard
production item from the supplier's current inventory provided the workboat
platform meets the requirements of the specification and is representative of
the design, construction, and manufacturing techniques applicable to the
remaining workboat platforms to be furnished under the contract.
4.4 Quality conformance inspection. The quality conformance inspection
shall include the examination of 4.5, the tests of 4.6, and the packaging
inspection of 4.7. This inspection shall be performed on the samples selected
in accordance with 4.3.
4.5 Examination. Each workboat platform shall be examined for compliance
with the requirements specified in section 3 of this specification. Any
redesign or modification of the contractor's standard product to comply with
specified requirements, or any necessary redesign or modification following
failure to meet specified requirements shall receive particular attention for
adequacy and suitability. This element of inspection shall encompass all visual
examinations and dimensional measurements. Noncompliance with any specified
requirements or presence of one or more defects preventing or lessening maximum
efficiency shall constitute cause for rejection.
4 6 Tests.
The first article shall receive the tests of 4.6. Each
Failure to pass any test shall
production unit shall receive the test of 4 6.2
constitute cause for rejection.
4.6.1 Test plan
A written test plan for the performance of the tests of
4.6 2 through 4.6.10 shall be prepared and submitted to the Government
contracting officer by the contractor at least two weeks prior to the
commencement of tests as specified in the contract. The test plan shall
include, but not be limited to, the following:
Calendar schedule for performance of the tests.
a.
b.
Location and brief description of facilities to be used for the tests.
Procedure out 1 ine for performance of each of the tests
c.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals