 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-45575
4.5.2.1.2 Each pistol in the inspection lot shall be examined In
accordance with Table IV.Failure of a pistol to pass any of the
examinations in Table IV shall be cause for rejection of the pistol.
TABLE IV
Requirement
Characteristic
3.2.3.2
Final protective finish
3.2.4
Firing mechanism
3.2.4.2
Firing pin
3.2.5
Trigger
3.2.6
Magazine
3.2.7
Safety device
3.2.8
Sights
3.2.9
Side or bolt stop
3.2.10
Grips
3.5
Marking
3.6
Identification
3.7
Workmanship
4.5.2.1.3 After completion of all testing and just prior to pack-
aging, each pistol in the inspection lot shall be reexamined for Firing
Pin 3.2.4.2 and Trigger 3.2.5. Pistols failing to meet the requirements
shall be rejected.
4.5.2.2 Packaging. Examination of packaging shall be in accordance
with MIL-P-14313.
4.5.3 Testing.
4.5.3.1 Failure data. Unless otherwise specified herein, all
tests shall be conducted on a complete pistol. If test requirements
cited herein are not met, acceptance of the pistal shall be deferred and
the contractor shall accomplish as applicable, the following actions:
Conduct a failure analysis study performing a physical
a.
and visual examination of the components which are
suspected tG be the cause of failure or malfunction.
Evaluate and correct the applicable production processes
b.
and procedures to prevent recurrence of the same defect(s)
in future production.
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals