 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-71012A(AR)
2.2 Order of precedence. In the event of a conflict between
the text of this document and the reference cited herein, the text
of this document shall take precedence. Nothing in this document,
however, shall supersede applicable laws and regulations unless a
specific exemption has been obtained.
3.
REQUIREMENTS
3.1 First Article. Unless otherwise specified in the
contract or purchase order, a sample shall be subjected to first
article inspection in accordance with the technical provisions
herein. Unless otherwise specified, the first article shall
include the pilot pack. (See 4.4 and 6.2).
3.2 Materials and construction. The pistol and component
Parts shall conform to the applicable material, construction and
dimensional requirements of MIL-W-13855 and as specified herein.
Parts and surfaces subject to rolling or sliding contact shall be
of sufficient hardness to resist wear. Staked or dovetailed
members shall have sufficient temper to retain their original fit
after extended use. Screws, when firmly tightened, shall not
cause binding of any of the mechanism. External pins shall be
secured in position by detent or retainer.
3.3 Design. The pistol and component parts shall conform to
the applicable design requirements specified in MIL-W-13855 and as
specified herein.
3.3.1 General requirements. The pistol shall be a magazine
fed, semiautomatic pistol conforming to the following physical
requirements:
Length --------------------- ------------ 198mm {7.8 in.) max
Height ------- ---------------------
137mm (5.4 in.) max
Width ------ ------ ------ ------ ------ ---- 37mm (1.45 in.) max
Weight (with unloaded magazine) - - -- - -- - .894 kg (31.5 oz.) max
Magazine capacity - --- --- - - - -- - -- - -- --- - 8 rounds minimum
3.3.1.1 Operation. The pistol shall be capable of being
placed into operation with either hand after loading. The pistol
shall be capable of allowing multiple strikes on an ammunition
primer by multiple pulls on the trigger alone.
3.3.2 Caliber. The caliber of the pistol shall be 9MM NATO.
The pistol shall be capable of meeting all requirements specified
herein when firing M882 9MM ball ammunition. The pistol shall
also function with commercial subsonic and supersonic controlled
expansion ammunition. The pistol must function with above
ammunition without substitution or exchange of parts.
3.3.3 Magazine and magazine catch. The magazine shall be
free of defects which may affect functioning of either the
magazine or the pistol. The magazine follower and the magazine
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals