 |
|||
|
Page Title:
Firing Pin and firing pin spring |
|
||
| ||||||||||
|
|  MIL-P-71012A(AR)
catch shall function without binding throughout their full range
of travel. The magazine shall be positively retained in place in
the receiver by the magazine catch. When the magazine catch is
depressed,it shall disengage the magazine and the empty magazine
shall drop out of the receiver of its own weight. The magazine
release shall be located at the rear of the trigger guard and be
accessible by the firing hand of both left and right handed users.
Slide. The slide shall function without binding
3.3.4
through its range of travel on the receiver guide ways.
3.3.5 Barrel. The minimum barrel length shall be 89mm (3.5
in). Burrs and sharp edges shall be removed from chamber edges.
Scratches or marks, occurring in a chamber which otherwise meets
best commercial surface roughness requirements, shall be permitted
provided they do not cause marks on the case of a high-pressure
test
Cartridge
fired
in
the
c h a m b e r .~
3.3.6 Sights. The front and rear sight shall be fastened
securely in place so that there will be no relative movement due
to firing. The rear sight shall be drift adjustable for
deflection. Both front and rear sights shall be replaceable and
completely interchangeable between types. Three dot horizontally
aligned sights are required. Tritium sights will be clearly
stamped or engraded with a "T" on an external surface that is
visible when the sight is installed on the pistol. Tritium sights
must be exempt from licensing by the Nuclear Regulatory Commission
as specified-in Title 10 Code Of Federal Regulations (10 CFR).
Safety
Mechanisms.
3.3.7
3.3.7.1 Firing pin safety. The pistol shall contain a
mechanism that locks, blocks, interdicts, or otherwise renders the
firing pin Inoperable until the mechanism is disengaged by
deliberate movement of the trigger in the rearward direction.
mechanism. If the fire control system does
3.3.7.2 Dococking
not automatically return to a rest position (no stored energy) at
the completion of each firing cycle, a decocking mecanism must be
provided to safely return the firing mechanism from the fully
cocked position to the uncocked position without actuating the
trigger.
3.3.7.3 Loading safety. The pistol shall be capable of being
loaded, unloaded, and cleared without actuating the trigger.
disconnect. The pistol shall not have a
3.3.7.4 Magazine
magazine discomector.
3.3.8 Firing Pin and firing pin spring. The firing pin and
firing pin spring shall be retained in the slide. The firing pin
spring shall hold the firing pin to the rear of the breech face of
the Slide and shall retract the firing pin into the slide after
each firing.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals