 |
|||
|
|
|||
| ||||||||||
|
| MIL-R-1296F(AR)
(Continued)
4.4.3.3
NOTES:
1 Failure of any item in the sample to pass the test shall cause
retest or rejection of the represented lot. At the discretion
of the Government representative, a retest may be allowed
without reconditioning the lot. Sample size for the test
shall be ten (10) items. Failure in the retest shall cause
rejection of the represented lot subject to reconditioning.
Failure of a test of the larger size lot shall cause rein-
statement of the smaller lot size until five consecutive lots
have again passes (see 4.5.1).
2 The tests for functioning, targeting and accuracy may be
perfomed concurrently.
3
Rear sight requirements (see 3.2.6.1) may be tested with the
sights separate from the rifle if the contractor can demon-
strate that the results are consistent with those obtained when
sights are tested to assembled rifles. At the contractor's
discretion, he may choose to conduct the rear sight test on a
lot basis rather than on each rifle.
4 At the contractor's discretion, he may choose to conduct the If
trigger pull test on a lot basis rather than on each rifle.
the contractor chooses to conduct the tizgger pull teSt on a
lot basis, he shall still be required to test each individual
rifle to assure that its trigger is adjusted within the range
of three and one half (3 1/2) to four and one half (4 1/2)
pounds before it is shipped.
5 Failure of a rifle to meet this requirement shall cause
rejection of the individual rifle.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals