 |
|||
|
Page Title:
Inspection of materials and component |
|
||
| ||||||||||
|
|  MIL-P-46067B(MR)
4.2 Sampling for inspection and acceptance . Sampling for inspection and
acceptance shall be performed in accordance with the provisions set forth in
MIL-STD-105, except where otherwise indicated. For purposes of sampling, an
inspection lot for examination and tests shall consist of all material of the
same type submitted for delivery at one time.
4.2.1 Inspection of materials and components . In accordance with 4.1
above, the supplier is responsible for insuring that materials and components
used were manufactured, examined, and tested in accordance with the
requirements of this specification and, to the extent specified, of all
referenced subsidiary specifications and standards. In the event of conflict,
this specification shall govern. A supplier's certification of compliance
with 3.1 and 3.3 shall be furnished.
4.2.2
Inspection of material .
4.2.2.1 Examination of the material . Examination of the material shall be
in accordance with the classification of defects, inspection levels and
acceptable quality levels (AQLs) set forth below. The lot size, for purpose
of determining the sample size in accordance with MIL-STD-105, shall be
expressed in the units of 22.6 kg (50 pounds) for examination in 4.4.2.1.1,
and in units of shipping containers for examination in 4.4.2.1.2.
4.2.2.1.1 Examination of the material for defects in appearance and
workmanship. The sample unit for this examination, specified in table II,
shall be approximately one pound selected just prior to the closure operation.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals