 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-63334(AR)
NOTE:
The tests for characteristics 304 through 318 inclusive, in
Table VII, shall be conducted at temperatures of -65 and
+150F, The test for characteristic 319 shall be conducted at a
temperature between +60 and +90F.
4.4.3 Failure of sample. Should any one item of a special sampling fail
to meet the specified test requirements, acceptance of the product shall be
suspended by the Government until necessary corrections have been made by the
contractor and resubmitted samples have been approved (see 4.3.3).
4.5 Inspection equipment. Except as otherwise provided for by the con-
tract, the contractor shall supply and maintain inspection equipment in accor-
dance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment. Where the contract
provides for Government furnished test equipment, supply and maintenance of
test equipment shall be inaccordance with the applicable requirements speci-
fied in MIL-145607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design. Unless otherwise specified in the contract,
all inspection equipment specified by drawing number in specifications or SQAP
forming a part of the contract shall be supplied by the contractor in accor-
dance with technical data listed in the technical data package (TDp).
4.5.2.2 Contractor design. The contractor shall design and supply
inspection equipment compatible with the "Test Methods and procedures" speci-
fied in 4.6 of this specification and with the component inspection procedures
specified in "Examination" and "Test Facilities" requirements of MIL-F-13926.
Since tolerance of test equipment is normally considered to be within 10% of
the product tolerance for which it is intended, this inherent error in the
test equipment design must be considered as part of the prescribed product
tolerance limit. Thus, concept, construction, materials, dimensions and
tolerances used in the design of test equipment shall be so selected and
controlled as to insure that the test equipment will reliably indicate accept-
ability of a product which does not exceed 90% of the prescribed tolerance
limit, and permit positive rejection when nonconforming. Construction shall
be such as to facilitate routine calibration of test equipment.
4.5.2.3 Inspection equipment design requirements.
4.5.2.3.1 Vibrating machine. The vibrating machine shall be capable of
providing the amplitude and frequency specified in 3.4.1. The vibrating
machine shall also be capable of vibrating the panel assembly along 3 mutually
perpendicular axes while the panel assembly is maintained with its longitudinal
axis in a horizontal plan.
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals