Power Unit, Aircraft, Auxiliary, Gas Turbine, General Specification

• Power Unit, Aircraft, Auxiliary, Gas Turbine, General Specification
• Government Documents
• Specifications and Standards
• Other Government Documents
• Order of Precedence
• Interface Definition
• Externally Applied Forces
• Limiting Temperatures
• Air and Gas Leakage
• Steam Ingestion
• Compressed Air Contamination
• Radar Cross Section (RCS)
• Performance Ratings
• Documents Requirements
• Performance Curves
• Maximum Operating Limits
• Rotor Speed Limits
• Operating Characteristics
• Weight of Fluids
• Depot Level Maintenance
• Ambient Temperature Conditions
• Icing Conditions
• Sand and Dust Ingestion
• Acoustic Noise Environment
• Corrosion Protection
• Nameplate and Product Marking
• Purging of Combustible Fluids
• Hot Parts Structural Life
• Design Material Properties
• Disc Burst Speeds
• Design Control
• Design and Construction Changes
• Modular Concept
• Facilities and Facility Equipment
• Fuel Control
• Safety Unit
• Fuel System Performance
• Fuel Pump Priming
• Electrical Interface
• Instrumentation Interface
• Temperature Sensing Systems
• Lubricating System
• Oil Reservoir Capacity
• Chip Detectors
• Starter Energy Source Interface
• Exhaust Duct
• Manner of Test and Reporting
• Automatic Recording Equipment
• Accuracy of Data
• Item of Data
• Relative Humidity Data
• Summary Reports
• Engineering Evaluation Tests
• Pressure Balance Verification
• Overspeed Test (PFRT)
• Endurance Test Requirements (PFRT)
• Slow Transient Run
• Random Transient Run
• Control System Recalibration (PFRT)
• Endurance Test Completion (PFRT)
• Fuel Pump Altitude Test
• Altitude Test Procedure (PFRT)
• Rotor Structural Integrity (PFRT)
• Attitude Test
• Control System Calibration
• Endurance Test Schedule (VT)
• Recalibrations (VT)
• Endurance Test Completion (VT)
• Component Calibration
• Fuel Pump Test Cycle
• Control System Test Cycle
• Ignition System Test Cycle
• High Temperature
• Fuel Pump
• Ignition System
• Fuel Pump Cavitation
• Component Calibrations
• Explosion- Proof (VT)
• Carbon Fouling
• Generator/Alternator Test
• Altitude Tests (VT)
• Altitude Test Procedure (VT)
• Environmental and Ingestion Tests
• Low and High Temperature Starting and Acceleration Test
• Environmental Icing Test
• Bird Ingestion Test
• Ice Ingestion Test
• Atmospheric Water Ingestion Test
• Exhaust Gas Emission Tests
• Infrared Radiation Test
• Emergency Fuel Test
• Rotor Structural Integrity (VT)
• Disc Burst Test (VT)
• Gyroscopic Test
• Test Apparatus
• Fuel Servicing
• Acceptance Test Log Sheet
• Preliminary Data
• Initial Run
• Penalty Run
• Maximum Hours of Running
• Acquisition Requirements
• Data Requirements
• Data Requirements -Cont.
• Definition and Symbols
• Acquiring Service
• Gulping Volume
• Unscheduled Maintenance
• Power Section
• Failures-Chargeable
• Using Service
• Instructions for Preparation
• Approval Status
• Instructions for Preparation of APU Summary
• Specific Features
• Specific Features -Cont.
• Size and Weight
• Utilization
• Table I. Minimum Uninstalled Performance at Standard Sea Level Static Conditions
• Table II. Minimum Uninstalled Altitude Performance
• Table III. APU Characteristics Summary
• Table IV. Pads and Drives
• Table V. Computer Program Requirements
• Table V. Computer Program Requirements -Cont.
• Table V. Computer Program Requirements -Cont.
• Table VI. Sea Level Anti-Icing Conditions
• Table VII. Mission, Mission Mix and Component Life
• Table VII. Mission, Mission Mix and Component Life -Cont.
• Table VIII. Fuel Contaminants
• Table IX. Data Recording
• Table X. Corrosion Susceptibility 48-Hour Test Cycle Schedule
• Table X. Corrosion Susceptibility 48-Hour Test Cycle Schedule -Cont.
• Table X. Corrosion Susceptibility 48-Hour Test Cycle Schedule -Cont.
• Figure 1. Externally Applied Forces
• Figure 2. Ambient Temperature Extremes
• Figure 3. Uninstalled APU Performance
• Figure 4. Droop Characteristics and Load Combinations
• Figure 5. APU Starting, Operating and Nonoperating Envelopes
• Figure 6. Operating Attitude and Storage Limits
• Figure 7. Continuos Maximum Icing Conditions
• Figure 8. Intermediate Maximum Icing Conditions
• Figure 9. Ambient Temperature Distribution
• Figure 10. APU Test Points and Altitude Ranges
• Numerical Index
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Numerical Index -Cont.
• Alphabetical Index
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Alphabetical Index -Cont.
• Numerical Index of Tables and Figures
• Standardization Document Improvement Proposal
• Business Reply Mail
• Blank Page

Power Unit, Aircraft, Auxiliary, Gas Turbine, General Specification

Privacy Statement - Press Release - Copyright Information. - Contact Us