 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-23016(Wep)
82 ohms
Resistance
82 ohms
Impedance (mainly resistive)
150 to 5,000 cps
Frequency Range
Less than 5%
Total Harmonic Distortion
0.01 to 3.5 volts rms
Open Circuit Output Potential
0-3.5 Volts RMS (to indi-
Meter, AC
cate voltage on the
microphone line).
0-100 ma.
Meter, DC
Receiver Performance:
3.3.2
3 General:
3.3.2.1
Unless otherwise specified, values set forth to establish the
requirements for satisfactory performance apply to performance
under both standard and extreme service conditions. When
reduced performance under the extreme conditions is acceptable,
tolerances or values setting forth acceptable variations from
the performance under the standard conditions will be specified.
All receiver tests are specified using "hard" microvolt.
Frequency Characteristics:
3.3.2.2
It shall be possible to receive on any carrier frequency in
the range of 2 to 29.999 mc. Voice reception with suppressed
carrier or continuous carrier shall be available on all such
frequencies. Carrier frequencies shall be located at increments
of 1000 cps throughout the frequency range commencing with
2.000 mc. Revisions shall be made for direct carrier frequency
readout of 28,000 channels. The equipment shall be calibrated
in terms of carrier frequency. Provision for teletype opera-
tion utilizing two audio tones shall be incorporated in the data
mode. In CW mode the control unit selected frequency shall be
1000 cps below the desired "carrier" frequency and in the data
mode the selected frequency will normally be 2000 cps below the
desired "carrier" frequency.
Sensitivity
3.3.2.3
AM -
The sensitivity of the receiver in the AM mode over the
103
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals