 |
|||
|
Page Title:
Contractor furnished inspection equipment |
|
||
| ||||||||||
|
|  MIL-R-50746(MU)
8 August 1973
4.5 Inspection equipment. Except as otherwise provided for by
the contract, the contractor shall supply and maintain inspection equiP-
-
ment in accordance with the applicable requirements of MIL-I-45607.
The inspection equipment listed in table V shall be utilized in performing
the tests specified herein.
4.5.1 Government furnished inspection equipment. Where the
contract provides for Government furnished inspection equipment,
supply and maintenance of the inspection equipment shall be in accordance
with the applicable requirements specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment
4.5.2.1 Government design. Unless otherwise specified in the
contract, all inspection equipment specified by drawing number in speci-
fications or SQAPS forming a part of the contract shail be supplied by the
contractor in accordance with applicable technical data listed in the TDP.
4.5.2.2 Contractor design. The contractor shall design and
supply inspection equipment compatible with test methods and procedures
specified in 4.6 of this specification and with the component inspection
procedures specified in examination and test facilities provisions of
MIL-F-13926. Since tolerance of inspection equipment is normally con-
sidered to be within 10 percent of the product tolerance for which intended,
this inherent error in the inspection equipment design must be considered
as part of the prescribed product tolerance limit. Thus, concept, con-
struction, materials, dimensions, and tolerances used in the design of
inspection equipment shall be so selected and controlled as to ensure
that the inspection equipment will reliably indicate acceptability of a pro-
duct which does not exceed 90 percent of the prescribed tolerance limit
and permit positive rejection when nonconforming. Construction shall be
such as to facilitate routine calibration of inspection equipment.
4.5.2.2.1 Pressure tester. Special test equipment (STE) in
accordance with Drawing F8565556 or equivalent, shall be provided to
check the sealing of unit.
4.6 Test methods and procedures.
4.6.1 Test conditions. Unless otherwise specified, the test
conditions shall be in accordance with the test facilities provisions
of MIL-F-13926.
23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals