 |
|||
|
Page Title:
First article inspection failure. |
|
||
| ||||||||||
|
|  MIL-R-62197A(AT)
4.3 Inspection conditions. Unless otherwise specified herein, all inspections shall be
performed under the following standard (room) ambient conditions:
a. Temperature: 77 + 18F.
b. Relative humidity: Uncontrolled room ambient.
c. Atmospheric pressure: Site pressure.
4.4 First article inspection. First article inspection shall be performed on preproduction
and initial production samples as specified herein. Approval of the first article sample by the
Government shall not relieve the contractor of the obligation to supply relays that are fully
representative of those inspected as a first article sample. Any changes or deviations of the
production units from the first article sample shall be subject to the approval of the contracting
officer.
4.4.1 Preproduction inspection. When specified (see 6.2), the preproduction sample
shall consist of two relays. Preproduction inspection shall consist of inspection as specified in
table I and the examination of 4.5.2.
4.4.2 Initial production inspection. Unless otherwise specified (see 6.2), the Government
shall select two from the first ten relays produced under the production contract for initial
production inspection. The initial production sample shall be inspected as specified in table I,
and examined as specified in 4.5.2.
4.4.3 First article inspection failure. Deficiencies found during, or as result of, the first
article inspection shall be caused for rejection of the first article sample until evidence has been
provided by the contractor that corrective action has been taken to eliminate the deficiency. Any
deficiency found during, or as a result of, the first article inspection shall be evidence that all
items already produced prior to completion of the first article test are similarly deficient unless
contrary evidence satisfactory to the contracting officer is furnished by the contractor. Such
deficiencies on all items shall be corrected by the contractor. The Government will not accept
products until first article inspection is completed to the satisfaction of the Government.
4.5 QCI. QCI shall include the examination of 4.5.2 and the tests of 4.5.3.
Noncompliance with any of the specified requirements in sections 3 and 5 shall be cause for
rejection of the sample and the inspection lot.
4.5.1 Sampling plan. Unless otherwise specified (see 6.2), the sampling plan specified
herein shall be used. See 6.4 for definitions of sampling inspection terms.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals