 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-70503A(AR)
Manufacturer's name and FSCM number
Part number
Serial number
Date of manufacture
3.9 Workmanship. The workmanship shall be in accordance with
high-grade helicopter construction practices and shall meet the
quality assurance provisions of this specification. Workmanship
shall be in accordance with MIL-E-5400.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection and standard quality
assurance provisions. Unless otherwise specified herein or in the
contract, the provisions of MIL-W-63150 shall apply and are hereby
made a part of this detail specification. Except as otherwise
specified, the supplier may utilize his own facilities or any
commercial laboratory acceptable to the Government. The Government
reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to
assure that supplies and services conform to prescribed
requirements.
4.2 Certification of provisions. The certification
provisions of MIL-W-63150 shall apply.
4.3 Classification of inspe ction. The following types of
inspection shall be conducted on this item.
First Article Inspection.
a.
Quality Conformance Inspection.
b.
4.4 First article inspection.
4.4.1 Submission. The contractor shall submit a first
article sample as designated by the Contracting Officer for
evaluation in accordance with provisions of 4.4.2. The first
article sample shall consist of one Rocket Management Subsystem.
4.4.2 Inspections to be performed. First article assemblies
components, and test specimens may be subjected by the Government,
at a place designated by the Government, to any or all of the
examinations and tests specified in the item detail specification
and to any or all of the-requirements of the applicable drawings.
See Table IV specified herein.
4.4.3 Rejection.
If any assembly, component, or test
specimen fails to comply with any of the applicable requirements,
the first article sample shall be rejected. The Government
reserves the right to terminate its inspection upon any failure of
an assembly, component, or test specimen in the sample to comply
with any of the stated requirements.
20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals