 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-81158A(WP)
3.4.1.1 Continuity shall exist between each pin of J801 and the cor-
responding pin or pins of P801, as depicted on BUWEPS Dwg 1576603.
3.4,1.2 Continuity shall exist between each pin of J802 and the cor-
responding pin or pins of P802, as depicted on BUWEPS Dwg 1576603.
3.4.1.3 Continuity shall exist between each pin of J803 and the cor-
responding pin or pins of P803, as depicted on BUWEPS Dwg 1576603.
3.4.1.4 Continuity shall exist between each pin of J804 and the cor-
responding pin or pins of P804, as depicted on BUWEPS Dwg 1576603.
3.4.2 Dielectric. The rear cover shall withstand the specified poten-
tials without breakdown, puncturing of insulation, or arcing when tested
as specified in 4.4.4.2.
3.4.2.1 The dielectric withstanding voltage for connector 801 shall
be 1000 volts rms at 60 cps for one minute, applied between each pin
and all other pins and the connector shell, except for pin M. The dielec-
tric withstanding voltage for pin M shall be 2400 volts rms at 60 cps for
one minute applied between pin M and all other pins and the connector
shell.
3.4.2.2 The dielectric withstanding voltage for connector 802 shall
be 1000 volts rms at 60 cps for one minute applied between each pin and
all other pins and the connector shell.
3.4.2.3 The dielectric withstanding voltage for connector 803 shall
be 1000 volts rms at 60 cps for one minute applied between each pin and
all other pins and the connector shell.
3.4.2.4 The dielectric withstanding voltage for connector 804 shall be
1000 volts rms at 60 cps for one minute applied between each pin and all
other pins and the connector shell.
3.4.3 Insulation resistance. The rear cover shall meet the minimum
insulation resistance requirements when tested as specified in 4.4.4.3.
3.4.3.1 With an applied voltage of 500 volts dc the insulation resist-
ance shall be 30 megohms between each wire and all other wires and the
connector shell. This test is to be performed on all connectors.
3.4.4 Direct current resistance. The rear cover shall meet the mini-
mum direct-current resistance requirements when tested as specified in
4.4.4.4.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals