|
| ![]() MIL-R-85325(AS)
Functional test. Each bomb rack mounted in a horizontal
4.6.2
position, shall complete the following tests.
WARNING
The bomb rack shall not be fired
without a reactive store load im-
posed on its ejector foot.
a.
The rack shall be cocked mechanically and the safety
pin installed. The latch sear line shall be visu-
ally inspected to determine that each hook is secure-
ly latched. Failure of a sear to properly contact
and lock the hook shall constitute a critical defect.
Apply 28 Newton-meters (250 inch-pounds) maximum
torque to the manual release. The release mechanism
shall not actuate.
b.
Remove the safety pin and actuate the manual release
The release mechanism shall operate
mechanism.
smoothly and the hooks shall open.
Repeat a. and b. four times.
c.
Suspend a 113 kilogram (250 pound) store from the
d.
355.6 millimeter (14 inch) hooks of the bomb rack,
latching the hooks securely. Tighten the forward
and aft set of swaybraces as follows:
Hand tighten all braces until the pads lightly
1.
contact the store.
Tighten forward starboard pad 1/4 turn.
2.
Tighten aft port pad 1/4 turn.
3.
4.
Tighten forward port pad 1/4 turn.
Tighten aft starboard pad 1/4 turn.
5.
Repeat tightening in order of steps 2 through 5
6.
to attain 3/8 turn total on each swaybrace.
Repeat b. The store shall release with a maximum of
e.
28 Newton-meters (250 inch-pounds) torque applied to
the manual release.
7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |