 |
|||
|
Page Title:
Table 111 - Material examination |
|
||
| ||||||||||
|
|  MIL-S-1123E
reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure supplies
and services conform to prescribed requirements.
4.2 First article inspection.- When a preproduction sample is required,
it shall be examined in accordance with 4.4.1 and 4.4.2 and tested in
accordance with 4.5.1 and 4.5.2, as applicable.
4.3 Inspection.- Sampling for inspection shall be performed in
accordance with MIL-STD-105, except where otherwise indicated hereinafter.
4.3.1 Component and material inspection.- In accordance with 4.1
above, components and materials shall be inspected and tested in accordance
with all the requirements of referenced specifications, drawings, and
standards unless otherwise excluded, amended, modified, or qualified in
this specification or applicable purchase document.
4.3.1.1 Material examination.- In addition to the inspection in
4.3.1, an examination shall be made to determine that the components
in Table III conform to the requirements indicated, as applicable.
TABLE 111 - Material examination
Requirement
Component
Requirement
Paragraph
Material
3.5.4
Machine bases
Material
Guards
3.5.5
3.10.1
Material
Legs (type I machines)
3.10.1
Material
Frame (type I machines)
4.4 End product inspection.- The inspection lot shall be all items of
one type (and size, if applicable) offered for inspection at one time. The
sample unit shall be one completely assembled item.
4.4.1 Visual examination.- The completely assembled end item shall be
examined for completeness of assembly, defects in design, construction,
workmanship, finish, and marking and to assure that the end item is manu-
factured in accordance with specified requirements. The inspection level
shall be II and the AQL shall be 6.5 expressed in terms of defects per
hundred units.
4.4.2 Dimensional examination.- Examination shall be made for compliance
*
with dimensions specified herein. The inspection level shall be II and the
AQL shall be 6.5 expressed in terms of defects per hundred units.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals