 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-13261G(AR)
4.4.3 Production testing. Unless otherwise specified herein,
the following tests shall be performed using MIL-STD-105 for
sampling plan requirements.
(See Table II) Major Defect.
4.4.3.1 Moisture content
TABLE II
Inspection
Method
Drawing
Paragraph
Material
9251412
4.5.1.4
Delay composition
8797920
4.5.1.1
Black Powder
4.5.1.3
Green Star
8797956
Illuminant composition
White Star
4.5.1.2
8839489
Red Star
8839489
4.5.1.2
4.5.1.5
8797922
Cork
8797923
4.5.1.5
8797937
4.5.1.5
Felt
8797958
4.5.1.5
8797936
4.5.1.5
Paper
8797938
4.5.1.5
4.5.1.5
8797958
4.5.1.5
8797927
Chipboard
8797980
4.5.1.5
8797938
4.5.1.5
Fiberboard
8797941
4.5.1.5
Wood
8887530
4.5.1.6
Propellant assembly
8887529
4.5.1.6
Grain, propellant
7548414
4.5.1.5
Padding material (packing)
The contractor shall provide adequate controls to
Note:
insure that the materials comply with the
requirement. For verification, the contractor shall
select and subject to test, one sample of each
material from each eight hours production. A
composite sample shall not be used. If the moisture
content of a sample exceeds the requirements and
loading has not begun, the material represented by the
sample shall be rejected. If components have been
loaded with a material containing excessive moisture,
the remaining unloaded material and the loaded
components shall be rejected. Test procedures shall
be as specified in 4.5.1.
4.4.3.2 Functioning. The signal assemblies shall be observed
for any evidence of failure to comply with the requirements as
classified in Table III when tested as specified in 4.5.2.
31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals