 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-13303G(AR)
NOTE: The functioning test shall consist of four (4) distinct
phases: Hot temperature - fixture fired, plus 70 degrees - fixture
fired, cold temperature - fixture fired, and cold temperature - hand
fired. Reduced sampling will be authorized only with three (3)
consecutive lots have met the acceptance criteria specified in all
four (4) phases. Compliance with the criteria in any one phase will
not result in reduced sampling for that phase.
4.4.3.2.1 Hot temperature.
4.4.3.2. 1.1 First three (3) lots. Beginning with the first lot
produced and continuing until three (3) consecutive lots have
complied with the acceptance criteria specified, twenty-five (25)
assemblies shall be selected for this test. The lot shall be
rejected if, during the test, a critical defect occurs.
4.4.3.2.1.2 After three (3) consecutive lots. After three (3)
consecutive lots have complied with the criteria of 4.4.3.2.1.1, ten
(10) assemblies shall be selected from each lot for test. The lot
shall be rejected if during the test, a critical defect occurs.
4.4.3.2.2 Ambient 70 5F.
4.4.3.2.2.1 First three (3) lots. Beginning with the first lot
produced and continuing until three (3) consecutive lots have
complied with the acceptance criteria specified, one hundred and
twenty-five (125) assemblies shall be selected for this test. The
lot shall be rejected if, during the test, a critical defect occurs,
the average angle from the vertical exceeds the requirement, the
average altitude is less than the requirement or if eight (8) or
more assemblies exhibit any of the remaining major defects listed in
Table III.
40
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals