 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-13303G(AR)
4.5.7 Bolt pull strength. The bolts shall be tested in
accordance with the procedure and equipment specified in 4.4.4. Any
bolt which fails to comply with the applicable drawing requirement
shall be classed defective. (Destructive Test ) .
4.5.8 Hardness of tail vane. The tail vane shall be tested for
hardness as specified in F ederal Standard No. 151, Method 243.
4.5.9 Push test of firing cap and spring clip assembly. The
firing cap and spring clip shall
tested in accordance with the
equipment and procedure specified in 4.4.4. Any assembly failing to
comply with the applicable drawing requirement shall be classed
defective.
(Non-Destructive Test )
4.5.10 Weld peel test. The welds on the tail assembly shall be
tested in accordance with the procedures specified in MIL-W-12332.
After test the assembly shall be examined to determine compliance
with the drawing requirements. (Destructive Test)
4.5.11 Swivel pull test. The swivel shall be tested applying
the specified weight in accordance with the procedures and equipment
specified in 4.4.4.
(Destructive Test )
5.
PACKAGING
5.1 Preservation.
6.
NOTES
6.1 Intended use. The components covered by this specification
are intended for use on the Signals, Smoke, Ground, Hand Held
Parachute, Green Smoke, M128A1 Red Smoke, M129A1 and Yellow Smoke
M194.
6.2 Ordering data.
See MIL-A-48078.
46
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals