 |
|||
|
|
|||
| ||||||||||
|
|  MIL-s-17000/12(sH)
.
Terminal boards:
Ship wire terminal boards shall be mounted vertically.
Terminal board and marking shall be in accordance with Drawing
417-5476790, connector receptacles marking, shall be as shown on Drawing
417-5476782. The 21 terminal boards shall be arranged as shown on Drawing
417-5476783 (sheet 3). The terminal board modules shall be hinged on the
bottom edge. The hinge-shall be in accordance with MS 35824 and permit the
module to open to a maximum of 130 degrees. The terminal board module shall
be held in an upright position by captive screw-type fasteners-made of
corrosion resistant steel type 303 and with a screw thread size of 1/4-20.
The horizontal edge of the module shall be covered with insulationmsterial
to prevent chafing of ship cables.
Module A through F wiring arrangement: Module A through F wiring arrange-
.
.
ment shall be in accordance with the foLlowing:
Ship cables shall terminate in connector plugs in accordance
(a)
with MS 3406 with strain relief clamps in accordance with
MIL-C-5015.
(b)
Only wiring for active circuits shall be installed from the
ship cable connector receptacles to the module connection
point and to the harness wiring connector receptacles.
." (c)
Wiring from the ship cable connector receptacles shall be
connected to the front of the terminal boards. All other
module wiring shall be connected to the back of the terminal
boards.
(d) Adequate slack shall be left in the wiring to the terminal
boards from the ship connectors and the module connectors to
permit the front panel of the module to swing down to a
130-degree opening.
Modules:
Back section modules shall be arranged and mounted as shown on
Drawing 417-5476783 (sheet 3). These modules Shall be spaced 1 inch minimum
apart. Wiring between the connector receptacles, terminal boards, and door
mounted items shall be via flexible harness wiring. Ship cable connector
receptacles shall be in accordance with MIL-C-5015 and mounted on the inside
of removable connector module. These connector receptacles shall be mounted
on the inside of the module with the heads of the receptacle securing screws
on the outside of the modules.
Preparing activity:
Navy - SH
(Project 1290-N388)
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals