 |
|||
|
Page Title:
Determination of composition. Major defect |
|
||
| ||||||||||
|
|  MIL-S-20517H(AR)
4.4.3.3 Determination of composition. Major defect.
4.4.3.3.1 Flash powder (see dwg. 8848485). A sample of not
less than 5 g. shall be selected from each batch for test in
accordance with 4.5.3.2, using the procedure given in ASTM E300 for
solids. If the sample fails to comply with the requirement
specified the batch shall be rejected.
4.4.3.4 Charge case assembly (see dwg. 8848485) - Failure to
Fragment - Critical defect. Twenty (20) loaded charge case
assemblies shall be selected from each lot and subjected to static
functioning at the contractor's facility in accordance with the
method specified in 4.5.4. The lot shall be rejected if any charge
case assembly fails to comply with the drawing requirement.
(Destructive test)
4.4.3.5 Functioning.
See 3.4.
4.4.3.5.1 Beginning with the first lot produced and continuing
until three numerically consecutive lots (see Note) have complied
with the applicable requirements specified, two hundred (200)
simulator assemblies shall be selected from each lot for test. The
lot shall be rejected if, during the test, a critical defect occurs
or if seven (7) or more assemblies exhibit any of the remaining
major defects listed in Table III. The lot shall also be rejected
if the total of minor and major defects equal eight (8) or more when
tested in accordance with 4.5.5. (Destructive Test)
NOTE: Resubmitted lots shall not be used to meet the criteria
of "numerically consecutive lots".
TABLE III.
FUNCTIONING DEFECTS
32
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals