 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-3788G
3.7 Alignment accuracies.
Each shaper shall meet the following alignment
tests (see 4.7.3):
surface shall not exceed
a.
Spindle runout
on the cutter mounting
0.004 inch TIR.
b. Spindle end play shall not exceed 0.005 inch.
The spindle axis shall be square to the table workpiece support
c.
surface within 0.010 inch per foot TIR.
3.8 Standard equipment. All standard equipment normally provided with the
manufacturer's commercial machine shall be furnished.
3.9 Optional equipment.
Optional equipment shall be furnished as specified
and fully described (see 6.2). The optional equipment provided shall be
functional without requiring modification of the equipment or machine.
Required repair parts shall be furnished as specified
3.10 Repair
parts.
(see 6.2).
3.11 Marking on instruments.
control panels.
charts.
and plates. All
words on instruments, control panels, charts, and plates shall be in the
English language. Characters shall be permanently marked in boldface on a
contrasting background. All plates shall be corrosion resistant.
3.11.1 LU brication plate. When specified (see 6.2), a lubrication plate
shall be attached to each machine. Unless otherwise specified (see 6.2), the
information provided on the plate shall be as listed below:
Points of lubricant application
Servicing interval
Type of lubricant
Federal or military specification for each lubricant (if applicable)
3.11.2 Nameplate. A nameplate shall be securely attached to each machine.
Unless otherwise specified (see 6.2),
the nameplate shall contain the
information listed below:
Nomenclature
Manufacturer's name
Manufacturer's model designation
Manufacturer's serial number
Power input (volts, total amps, phase, frequency)
Amp rating of largest motor
Short circuit/over-current protection rating
Contract number or order number
National Stock Number or Plant Equipment Code
Date of manufacture
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals