 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-3788G
3.12 Workmans hip. Workmanship of the shaper and its accessories shall
meet all requirements specified herein.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements (examinations and tests) as specified herein.
Except as otherwise specified in the contract or purchase order, the
contractor may use his own or any other facilities suitable for the
performance
of the
inspection requirements
specified herein,
unless
disapproved by the Government. The Government reserves the right to-perform
any inspections set forth in the specification where such inspections are
deemed necessary to ensure supplies and services conform to prescribed
requirements.
4.1.1 Respo nsibilitv for compliance. All items shall meet all requirements
of sections 3 and 5. The inspections set forth in this specification shall
become a part of the contractor's overall inspection system or quality
program. The absence of any inspection requirements in the specification
shall not relieve the contractor of the responsibility of ensuring that all
products or supplies submitted to the Government for acceptance comply with
al 1
requirements of
the contract. Sampling inspection,
as part of
manufacturing operations, is an acceptable practice to ascertain conformance
to requirements;
however, this does not authorize submissions of known
defective material,
either indicated or actual,
nor does it commit the
Government to accept defective material.
4.2 Classification of inspections.
The inspection requirements specified
herein are classified as follows:
a.
First article inspection (see 4.4).
b. Quality conformance inspection (see 4.5).
4.3 Inspection conditions. Unless otherwise specified (see 6.2), all
inspections shall be performed in accordance with the test conditions
specified in 4.7.1.
4.4 First article inspection. When a first article inspection is required,
it shall be applied to the first article submitted in accordance with 3.1.
Unless otherwise specified (see 6.2), first article inspection shall consist
of the examination in 4.6 and all tests in 4.7. The machine shall pass the
examination and all tests to be accepted.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals