 |
|||
|
Page Title:
Lifting and tying down attachments. |
|
||
| ||||||||||
|
|  MIL-S-45152H
* 3.1.1.1 Treatment and painting. The vehicle shall be treated and painted in accordance with
MIL-STD-1223. As specified by the procuring activity for the appropriate service (see 6.2), the
exterior color shall be in accordance with MIL-STD-1223.
* 3.1.1.2 Marking and data plates. As specified by the procuring activity for the appropriate
military service (see 6.2), identification marking and data plates shall be in accordance with
MIL-STD-1223. When specified (see 6.2), concealed markings shall be furnished.
* 3.1.1.3 Rustproofing. When specified (see 6.2), the vehicle shall be rustproofed in
accordance with FED-STD-297.
3.1.1.4 Wood treatment. Wood, except apitong, shall be treated in accordance with
MIL-STD-1223.
* 3.1.1.5 Additional data plates. Additional data plates depicting the maximum towing speeds,
permissible loads and permissible load distributions (see 3.3 through 3.4), shall be provided. The
plates shall indicate the maximum towing speeds with and without payload, the maximum
concentrated payload for each four foot segment of the entire length of the semitrailer, including
the gooseneck, and the longitudinal location, length and width(s) of the maximum concentrated
loads permissible as specified in 3.3. Appropriate loading instructions and cautions, as
applicable to the manufacturer's design, shall be furnished on the plates. A plate shall be
provided on each side of the vehicle in a conspicuous location. The plates shall conform to
composition A (class 1 or 2) or composition C of MIL-P-514.
* 3.1.1.6 Lifting and tying down attachments. When specified (see 6.2), the semitrailer shall
be equipped with lifting and tying down attachments. Lifting and tying down attachments shall
conform to type II or type III of MIL-STD-209. A transportation plate conforming to
composition A (class l or 2) or composition C of MIL-P-514 shall be attached to the semitrailer.
The transportation plate shall be inscribed with a diagram showing the lifting attachments and
proposed lifting slings, the capacity of lifting attachments and proposed lifting slings, the
capacity of each attachment, and the required length and size of each sling cable. A silhouette of
the semitrailer, showing the center of gravity, shall be provided on the transportation plate.
Tiedown attachments shall be identified by stenciling or other suitable markings. Tiedown
markings shall clearly indicate that the attachments are intended for the tiedown of the
semitrailer on the carrier when shipped.
* 3.1.1.7 Lubrication chart. When specified (see 6.2), a lubrication chart shall be provided.
The chart shall direct attention to all lubrication fittings and specify the range and grade of
lubricants required for critical temperatures. The chart shall be permanently attached to the
semitrailer in a readily visible location. The chart shall be inscribed on a plate conforming to
composition A (class l or 2) or composition C of MIL-P-514.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals