 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-45152H
3.2 General design.
3.2.1 Federal Motor Vehicle Safety Standards. The vehicle shall comply with all Federal
Motor Vehicle Safety Standards applicable to the type of semitrailer furnished and in effect on
the date of manufacture.
* 3.2.2 Dissimilar metals. All dissimilar metals used throughout the vehicle shall be insulated
from one another to prevent galvanic or electrolytic action.
* 3.2.3 Ratings. Vehicle ratings shall be the manufacturer's published ratings. Component
and vehicular ratings shall not be raised to meet the requirements of this specification. When
published ratings are not available, verification of ratings shall be available to the appropriate
engineering office of the procuring activity.
* 3.2.4 Accessibility. The design of the vehicle and optional equipment shall permit access for
routine servicing and shall permit access for replacement and adjustment of component parts and
accessories with minimal disturbance of other components and systems.
*
3.2.5 Asbestos. Asbestos materials shall not be used in any form in any part of the vehicle.
* 3.3 Performance. The fully equipped semitrailer shall evidence no part failure, deformation,
permanent set or interference between parts when towed under each of the conditions specified
in table II. The semitrailer also shall show no part failure, deformation, permanent set or
interference between parts when towed on 15 percent side slopes, at speeds up to 10 mph, when
loaded as specified in 3.4 and when empty.
TABLE II. Performance.
Condition
Payload
Speed (minimum)
Unimproved roads; other
reasonably hard,
uneven terrain
None
10 mph
Unimproved roads; other
reasonably hard,
uneven terrain
Rated payload
10 mph
Highways
None
Sizes 15, 20, 25, 35:
55 mph
Sizes 50, 60, 75: 40 mph
Highways
Rated payload
Sizes 15, 20, 25, 35: 55 mph
*
Sizes 50, 60, 75: 30 mph
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals