 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-48573(MU)
4.3.2.3 Sightunit.- Examination and tests related to Section 3 here-
in shall be performed in accordance with the sampling plans specified in
Tables I and II herein. Examination and tests for packaging, packing and
marking shall be in accordance with MIL-P-14232 and Section 5 herein. The
tabulated classification of defects in Tables I and II shall constitute
the minimum inspection to be performed by the supplier after first article
approval and prior to Government acceptance or rejection by item or lot.
TABLE I - 100:.PERCENT (100%) INSPECTION
TEST PROCEDURE
REQUIREMENT
CHARACTERISTIC
NO.
4.6.1
3.5
Telescope clamping mechanism
1.
ThE test in Table I shall be conducted at a temperature between
NoTE:
+60 and +90F.
4.3.3 Acceptance and rejection.- The right is reserved to reject any
unit of product found defective during inspection whether the lot as a
whole is accepted or rejected. Rejected units may be repaired or corrected
and resubmitted for inspection with the approval of, and in the manner speci-
fied by the procuring activity.
4.4 Special sampling.
4.4.1 General.- Three sightunits shall be selected at random from
each 100 produced. The samples shall meet the requirements and tests in
Table II.
TABLE II
TEST PROCEDURE
REQUIREMENT
CHARACTERISTIC
NO
Applicable drawings
3.3, 3.3.1 &
Fabrication
301 l
and' specifications -
3.3.2
Visual
MIL-F-13926 - Visual
3.4
General specification
302.
4.4.2 Failure of sample.- Should any one item of a special sampling
fail to meet the specified test requirements, acceptance of the represented
inspection lot shall be suspended by the Government until necessary correc-
tions have been made by the contractor and resubmitted samples have been
approved (see 4.3.3).
4.5 Inspection equipment.- Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment
in accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment.- Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals