 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-50379(MU)
manufactured in the same manner, using the same materials, equipment, pro-
cesses, and procedures as used in regular production. All parts and
materials, including packaging and packing, shall be obtained from the
same source of supply as used in regular production.
4.2.1 Government testing.- When the Government is responsible for con-
ducting first article approval tests, the contractor, prior to submitting
the sample to the Government, shall inspect the sample to insure that it
conforms to all the requirements of the contract and submit a record of
this inspection with the sample, including certificates of conformance
for materials.
4.2.2 Contractor testing.- When the contractor is responsible for con-
ducting first article approval tests, the sample shall be inspected by
the contractor for all the requirements of the contract. The sample
and a record of this inspection, including certificates of conformance
for materials shall be submitted to the Government for approval. The
Government reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of Product.- Unless otherwise specified by the con-
tracting officer, inspection lot size, lot formation and presentation of
lots shall be in accordance with "Submission of Product" provisions of
MIL-STD-105.
4.3.2 Examination and tests.
4.3.2.1 Components and subassemblies.- All components and subassemblies
shall be inspected in accordance with the inspection provisions contained
in Supplementary Quality Assurance Provisions (SQAP) listed in the techni-
cal data package (TDP).In the absence of SQAP'S the applicable Quality
Assurance Provisions of MIL-F-13926 shall apply. Examination and tests
related to Section 3 herein shall be performed on a single defect (indiv-
ual characteristic) basis in accordance with MIL-STD-105 and the sampling
plans specified in Tables I and II herein. Examination and tests for
packaging, packing, and marking shall be in accordance with MIL-P-14232
and Section 5 herein. The tabulated classification of defects shall con-
stitute the minimum inspection to be performed by the supplier after first
article approval and prior to Government acceptance or rejection by item
or lot.
TABLE I
CLASSIFICATION
TEST PROCEDURE
REQUIREMENT
CRITICAL: NONE
MAJOR: AQL 1.0% Defective
4.6.1
3.3
Telescope retention
101 l
MINOR: l NONE
NOTE: The test in Table I shall be conducted at a standard ambient temper-
ature of between 60 and 90F.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals