 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-52506D(ME)
All parts, components, and assemblies of the seal including
3.14 Workmanship.
casting, molded parts, stampings, machined surfaces, and welded parts shall be
clean and free from sand, dirt, fins, pits, sprues, scale, flux, and other harmful
extraneous material. All edges shall be rounded or beveled.
4.
QUALITY ASSURANCE PROVISIONS
Unless otherwise specified in the contract
4.1 Responsibility for inspection.
or purchase order, the contractor is responsible for the performance of all
Except as
Inspection requirements (examinations and tests) as specified herein.
otherwise specified in the contract or purchase order, the contractor may use his
own or any other facilities suitable for the performance of the inspection
The
requirements specified herein, unless disapproved by the Government.
Government reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to ensure supplies and
services conform to prescribed requirements.
All items shall meet all requirements of
4.1.1 Responsibility for compliance.
The inspection set forth in this specification shall become a
sections 3 and 5.
part of the contractor's overall inspection system or quality program. The
absence of any inspection requirements in the specification shall not relieve the
contractor of the responsibility of ensuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
Sampling inspection, as part of manufacturing operations, is an
contract.
acceptable practice to ascertain conformance to requirements, however, this does
not authorize submission of known defective material, either indicated or actual,
nor does it commit the Government to acceptance of defective material.
4.1.2 Component and material inspection.
The contractor is responsible for
insuring that components and materials are manufactured, examined, and tested in
accordance with referenced specifications and standards, as applicable.
The inspection requirements specified
4.2 Classification of inspections
herein are classified as follows:
First article inspection (see 4.3).
a.
b.
Quality conformance inspection (see 4.4).
c.
Inspection of packaging (see 4.6).
4.3 First article Inspection.
4.3.1
The first article seal shall be examined as specified in
Examination.
4.5.1.
Presence of one or more defects shall be cause for rejection.
4.3.2 Tests.
The first article seal shall be tested as specified in 4.5.2.1
through 4.5.2.5.
Failure of any test shall be cause for rejection.
4.4
Quality conformance inspection.
4.4.1 Sampling.
Sampling for examination and tests shall be in accordance with
MIL-STD-105.
Sample size shall be determined by using MIL-STD-105 table I and
A lot shall be accepted when zero defects are found and rejected when
table IIa.
one or more defects are found.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals