Quality Conformance Inspection of Packaging.

Page Title: Quality Conformance Inspection of Packaging.
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-S-55257C(CR)

4.14 Electromagnetic interference test. The items stated in 3.18

shall be determined to comply with the requirements of 3.18. Test meth-

ods and procedures shall be in accordance with MIL-STD-462, Notice 3, as

implemented by a contractor prepared, Government approved, EMI Test Plan.

4.15 Cable Assemblies, power and audio frequency. Each cable as-

sembly shall be tested for continuity, dielectric, insulation resistance

and pull-out per MIL-C-3885. (See 3.11.6)

4.16 Tropicalization of materials. All materials of construction

shall be in accordance with the equipment drawings and shall be Fungus-

inert. Substitution of any materials other than specified must be ap-

proved by the contracting officer. The material will only be approved

after the contractor tests the material for Fungus-Resistance satisfacto-

rily in accordance with the requirements 508.1 of MIL-STD-81Oc.

4.17 Packaging inspection. Packaging inspection requirements spec-

ified herein are classified as follows:

First Article Inspection of Packaging.

Quality Conformance Inspection of Packaging.

4.17.1 First Article Inspection of Packaging. Unless otherwise

specified in the contract, First Article Inspection of Packaging shall be

in accordance with the Unit Pack Design Validation Requirements of MIL-P-

116.

4.17.2 Quality Conformance Inspection of Packaging.

4. 17.2.1 Materials inspection. All materials to be used in pack-

aging shall be inspected in accordance with the applicable material spec-

ification.

4. 17.2.2 Preservation inspection. Inspection of preservation and

interior markings shall be in accordance with group A and B Quality Con-

formance Inspection Requirement of MIL-P-116. Lot formation and sampling

procedures shall be as specified therein.

4. 17.2.3 Packing inspection. Inspection of packing and the marking

for shipment and storage shall consist of the examinations specified in

the Packing Inspection Provisions Table. Lot formation shall consist of

all packs made of the same materials during an identifiable period and-

submitted at one time for acceptance. Sampling procedures shall be in

accordance with MIL-STD-105, using a single sampling plan and Acceptable

Quality level of 4.0 percent defective.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business