 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-70745 (AR)
2.3 Order of precedence. In the event of a conflic between
the text of this specification and the reference cited herein
(except for related associated detail specifications,
specification sheets or MS standards) , the text of this document
Nothing in this document, however, supersedes
takes precedence.
applicable laws and regulations unless a specific exemption has
been obtained.
REQUIREMENTS
3.
3.1 Material. Material shall be in accordance with the
applicable drawings and specifications.
3.2 Strip. The strip shall comply with all requirements on
Drawing (Dwg.) 12902719, all associated drawings, and with all
requirements specified in applicable specifications.
3.3 Manufacturing process. The strips shall be manufactured
by the identical process used for first article sample and no
deviation from the process shall be made without prior approval of
the contracting officer.
3.4 Snap in assembly. The maximum force required to snap an
M848 dummy cartridge into any round position on the ammunition
strip shall not exceed (TBD) pounds.
The force required to disassemble the
3.5 Push out (nose).
nose end of an M848 dummy cartridge from the ammunition strip
shall be not less than (TBD) pounds nor more than (TBD) pounds.
The uncoated strip shall comply with the
3.6 Hardness.
hardness requirement of Note 8 specified on Dwg. 12902719.
3.7 Functioning. The strip shall be capable of being
assembled with 30mm cartridges and cycled through AH64
Uploader/Downloader system without binding, cracking, breaking,
separating or causing a malfunction.
3.8 Corrosion resistance. The strip, finished in accordance
with Note 7 of Dwg. 12902719, shall be exposed for 24 hours of
After exposure, the strip shall exhibit
salt spray (fog) testing.
no corrosion in excess of (TBD) disregarding cut edges for this
requirement.
3.9 Workmanship. The requirements for workmanship shall be
in accordance with MIL-W-63150, applicable drawings, referenced
specifications and the following:
The strip shall be free of blisters,
3.9.1 Metal defects.
seams, laminations, deep scratches and porosity. Cracks or tears
are not permitted in radii leading into each loop of the strip.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals