 |
|||
|
Page Title:
Quality conformance inspection sampling. |
|
||
| ||||||||||
|
|  MIL-S-81245(WP)
acceptance at the same time, except that the lot size shall not exceed
20,000 shields and 2000 holders.
4.4 Sampling.
4.4.1 Preproduction sample. A preproductlon sample of 600 shields
and 70 holders manufactured in accordance with 3.1 shall be subjected to the
following tests and inspections:
No. of
No. of
Method
Sample Units
Defective
Examination Requirement
Paragraph
Allowed
to be Inspected
Paragraph
or Test
Group I
0
40 shields
4.6.1.1
Material, Design,
3.2, 3.3,
0
and Workmanship
3.4, 3.6,
10 holders
and 3.11
Group II
0
3.7.1
4.6.1.2
10 shields
Salt Spray
0
5 holders
Group III
See 4.6.2.7.1
4.6.2.5
150 shields
3.5.1 and
Bench Tests
3.5.2
.
Group IV
See 4.6.2.7.2
400 shields
3.5.1 and
4.6.2.6
Flight Tests
3.5.2
Acceptance of the preproduction sample shall be based on no defects. Any
production by the supplier prior to approval of the preproduction lot shall
be at the supplier's risk.
4.4.2 Quality conformance inspection sampling. The sampling plans
and procedures set forth in Standard MIL-STD-105 shall be used in the
determination of acceptability of the shields and holders tested and .
inspected as specified in 4.5 and 4.6.1.
4.5 Examination.
4.5.1 Components. Prior to assembly of the shield and holder, it
shall be ascertained that all components procured under separate documents
have been inspected, tested, and accepted in accordance with their respective
documents.
4.5.2 Packing and marking. It shall be ascertained that packing and
marking of the shield assemblies conform to the requirements of Section 5
of this specification.
4.6 Tests 1
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals