 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-17491H (SA)
Castings not as specified.
107.
Welds not as specified, missing, incomplete, cracked, not
108.
correctly fused.
Lubrication and fittings not as specified.
109.
110.
Truck perceptibly out of square or alinement.
Plating not as specified, missing, or evidence of rust or
111.
corrosion.
Treatment and painting not as specified.
112.
Minor
Identification marking missing, incomplete, not legible.
201.
equipment manual missing, incomplete, not legible.
202.
Threaded fasteners missing, broken, stripped, or loose.
203.
Finish not dry, free of runs, sags area of no film wrong
204.
color.
Identification plate not as specified.
205.
4.5.2 Tests.
4.5.2.1 Test condition. Prior to test, the truck shall be lubricated with
oils and greases as recommended by the supplier. Test shall be conducted in
the order listed.
4.5.2.2 Rated load. Using a military pallet conforming to MIL-P-15011, with a
rated pallet load, insert forks into and raise the loaded pallet until the top
surfaces of the forks are elevated 4 inches (102 mm) above their fully lowered
position. Record the number of strokes and force requird to lift the rated
load while raising the forks from the fully lowered position to an elevation
4 inches (102 mm) above their lowered position. Nonconformance to 3.6.1 shall
constitute failure of this test.
4.5.2.3 Maximum load. Prior to conducting this test, and the test specified in
4.5.2.4, the pressure-relief valve,if provided,shall be made inoperative and
the truck shall be equipped with steel wheels. With the truck placed on a
surface plate and with forks at maximum height, the following heights shall be
measured, the points of measurement marked on the truck, and recorded:
(a) Front end of frame.
(b) Front pivot point of raising and lowering mechanism.
(c) Top of forks at heel on both sides.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals