 |
|||
|
|
|||
| ||||||||||
|
| MIL-T-18232B(AS)
3.1.25.1
GOVERNMENT FURNISHED EQUIPMENT. - Government furnished equip-
ment shall be as required by Appendix 1-A and 1-B of the
detail specification. Government furnished equipment shall not be altered,
reworked or modified in any way without specific permission of NAVAIR in each
case. Government furnished equipment required by Appendix 1-A of the detail
specification shall be installed by the contractor. Government furnished equip-
ment required by Appendix 1-B of the detail specification shall be installed by
the Government, however, the contractor shall make suitable provision therefor
and shall make a trial installation in the first target to insure satisfactory
operation. Drawings or samples of Appendix 1-B equipment will be furnished by
NAVAIR for trial installation. Contractor installation provisions shall insure that
all GFE equipment can be operated within specification requirements.
3.1.25.2
CONTRACTOR FURNISHED EQUIPMENT. - The contractor shall pro-
vide and install all necessary equipment and furnishings not
specified in Appendices 1-A and 1-B of the detail specification. Contractor
furnished equipment and furnishings, built to and meeting government specifica-
tions, shall not be altered, reworked, or modified in any way without specific
permission of NAVAIR in each case. Contractor furnished off-the-shelf electronic,
instrument, and automatic-pilot equipment shall not be altered} reworked, or
modified unless authorized by NAVAIR. Contractor furnished equipment shall be
listed in Appendix 1-C of the detail specification.
3.1.26
TARGET PROTECTION AGAINST FIRE. - Special consideration shall
be given to reducing the possibility of fire during servicing,
maintenance, and normal operation of the target.
3.1.27
PHYSICAL REFERENCES. - Physical references shall be provided
for measuring and leveling each target for weighing and for
structural alinement. Structural members which are parallel to the reference
planes shall preferably be used as the leveling references. A jig-located
structural member shall preferably be used as a jig point for taking measurements.
Alternatively, leveling lugs and a jig point fitting shall be provided. If such
fittings are externally located, they shall be readily detachable where necessary
to prevent adversely affecting target performance. Leveling provisions and the
jig point shall be identified by decal. The jig point decal shall include the
distance of the jig point from the reference datum for weight and balance purposes.
3.2
AERODYNAMICS
3.2.1
STABILITY AND CONTROL. - The target flying qualities shall be
adequate to permit satisfactory fulfillment of the mission and
utilization as specified. For this purpose, the target, when flown under the
control of the remote control stabilization system, shall be capable of steady,
stable flight from sea level to service ceiling with adequate damping. Adequate
damping is defined as damping of any oscillatory motion of the target to one-half
amplitude in three cycles or less. There shall be no tendency for undamped small
oscillations to persist. The detail specification shall specify the response time
of all the close loop airframe-autopilot control modes. In straight and level
flight, the target shall be capable of being controlled within the corridor width
specified in the detail specification for all altitudes and mission conditions
24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals