 |
|||
|
|
|||
| ||||||||||
|
|  ,
,
,
-
-
-
-
q
I
q at one time, with go `sc stw
one dimension
limitations. Grade B manufacturing gages
shall be designed to measure a m i n i m u m o f c o n f i d a n t Ins~pector until they have satisfac-
.!
one dimension at one time with go and not torily passed the applicable requirements of
.
.
go limitations-------. .
. . . . . . . . . -.
. this
folling
irements. Tool design shall
4.6 Design requ
meet the requirements of Section 3 for the
type and grade of tools specified in- the con-
is responsible for. tract. The contractor shall provide a complete
chase order, the* supplier
the performance of all inspection
set of drawings for visual inspection of design
ments as specified herein. Except as other-
by theGovernment inspector at the place
wise specified, the supplier may utilize his
of Operation. This inpection shall be per-
own facilities or any commercial labortory formed after the major problems of produc-
acceptable to the Government. The Govern- tiom have been recieved and not later than
ment reserves the right to perform any of the
30 days after reaching maximum production.
.
inspection set forth in the specification
where such inspections are deemed necessary
to assure supplies and services conform to
prescribed requirements.
4.2General requirements. Inspection re-
quirements and procedures shall be in accord-
ance with Specification MIL-I-45208.
4.3 Material. Material used in the manu-
facture of the tool shall be properly certified
by the contractor to insure compliance with
requirements according to the type and classi-
fication of the tool specified in 3.1.1.
4.4 Drawigs. Drawings shall be visually
and dimensionally inspected for compliance
with 3.1.1. Examination shall be based upon
the quality assurance of Specification MIL
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals