 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-481 34A (MU)
4.2.2.2.2 Inspection. - The 25 test set assemblies shall
be subjected to the following tests in the sequence indicated
in addition to the inspection of 4.3.2.21:
4.2.2.2.3 Rejection. - The first article sample shall be
rejected if any test set assembly fails to comply with any of
the applicable requirements. The Government reserves the right
to terminate its inspection upon encountering any failure to
comply with the stated requirements.
4.3 Inspection Provisions
4.3.1 Lot Formation. - The term "inspection lot" as used in
this specification is defined as an essentially homogeneous collec-
tion of units of product from which a representative sample is drawn
and inspected to determine conformance with applicable requirements.
The sample selected shall represent only that quantity of units from
which the sample was drawn and shall not be construed to represent
any prior or subsequent quantities presented for inspection. Homo-
geneity shall be considered to exist provided the inspection lot has
been produced by one manufacturer, in one unchanged process, using
the same materials and methods, in accordance with the same drawings,
same drawing revisions, same specifications and same specification
revision and complies with the provisions for submission of product
as specified in MIL-STD-105. Changes to the process, specification
or drawing not affecting safety, performance, interchangeability or
storage, as determined by the Government, shall not be deemed to
alter the homogeneity of an inspection lot. All material submitted
for inspection in accordance with this specification shall comply
with the homogeneity criteria specified herein regardless of the
type of sampling procedure which is being applied to determine
conformance with requirements. Lot numbering, as required, shall
be in accordance with MIL-STD-1168. Each inspection lot of test
sets shall contain parts of one lot interfix number from one sup-
plier.
4.3.2 Examination. - The examinations listed in the follow-
ing sub-paragraphs shall be performd on inspection lots (see
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals