 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-48558B(AR)
At +60F to +90F At -50F and +150F
Control
(+16 to +32C (-46 and +66C)
25 in. lbs. max.
5 to 9 inch lbs
Diopter
Adjustment
3.12.2 Attachment. The elbow telescope locking mechanism
3.12.2 Attachment.
The
shall be operable when exposed to the requirements of 3.7.2. The
telescope shall be retained in a manner representative of its use representative of its use
on the Mount, Telescope M172.
3.12.2.1 locating and locking bechanism. With the telescope
Locating and locking mechanism.
3.12.2.1
oriented per 3.6, oriented per 3.6, the latch or cam lock shall not loosen when the
telescope' is telescope is subjected to the requirements of Shock 3.7.3 or
3.7.4.1 or 3.7.4.2.
3.13
Illumination.
3.13.1 Reticle. The reticle markings shall be clearly
distinguishable when observed in ambient light conditions ranging
from dusk into darkness.
3.14 Interchangeability.
Telescope interchangeability shall
be verified by the insertion, seating, and subsequent removal of a
maximum fit gage.
3.15 Workmanship. The
workmanship
of
MIL-O-13830
and
MIL-F-13926 shall apply.
4.
QUALITY
ASSURANCE
PROVISIONS
4.1 Responsibility for inspection. Unless otherwise
specified in the contract or purchase order, the supplier is
responsible for the performance of all inspection requirements as
specified herein. Except as otherwise specified, the supplier may
utilize his own facilities or any other facilities suitable for
the performance of the inspection requirements specified herein,
unless disapproved by the Bovernment The Government reserves the
right to perform any of the inspection set forth in the
specification where such inspections are deemed necessary to
assure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet
all requirements of sections 3 and 5. The inspection set forth in
this specifications shall become a part of the contractor's
overall inspection system or quality program. The absence of any
inspection requirements in the specification shall not relieve the
contractor of the responsibility of assuring that all products or
supplies submitted to the Government for acceptance comply with
all requirements of the contract. Sampling in quality conformance
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals